Jiangsu Fucai Air Compressor Industrial Co.,Ltd.

Professional manufacturer of air compressor with high quality products and service

Home > News > Content
Air Compressor Application With Environmental Protection, Energy Saving And Efficient
- Jun 15, 2017 -

Air Compressor Application should pay attention to what safety measures? Air compressor safety measures are many, when used there are a lot of places should be noted that the use of the time should be strictly in accordance with the instructions to operate. Accidents or abnormal operation should be made with the purchase of air compressor sales in Chengdu to get in touch, and then allow professionals to repair.

(1) When the compressed air is cooled, it is necessary to blow off the mixture of coolers, gas cylinders and oil separators in a timely manner, at least once per hour.

(2) air compressor at work, if the cooling water supply is not timely, must be immediately parked for cooling.

(3) air compressor before starting, the cylinder and the cooler water jacket advanced water.

(4) in the cylinder water jacket is not completely cooled before, not water, to prevent the cylinder wall cracks.

(5) into the water jacket of the cooling water, should be set by the special water pressure drop into the sink, the water tank installed on the horizontal indicator scale, the level dropped below the limit, the signal device that effect; can also use centrifugal Pump water; do not directly use the water from the mine into the water, because it is difficult to see the water or not.

(6) Drain from the cylinder water jacket or cooler water jacket, must use an open stream to view the uninterrupted effect of all cooling equipment and measure the drainage temperature. Drain temperature than the water temperature shall not be higher than 20 ℃ -30 ℃.

(7) In order to prevent overpressure caused by blasting,Air Compressor Application in the compressor equipment should be equipped with a calibrated pressure gauge and safety valve.

(8) When the compressed air must be introduced into the lower pressure system, the equipment must be equipped with pressure reducer.

(9) In order to prevent the compressor system from cracking due to the ignition of the gas blasting mixture, the following measures must be taken:

1, the intake pipe should be located in the unclean gas, evaporation and dust, etc. mixed with the position. The inlet of the intake pipe should have a protective cover that prevents rain, snow and other debris from entering.

2, the air through the filter to completely remove the dust.

3, the cylinder out of the air, subject to the special water pipe cooler down to 25 ℃ -30 ℃ or so, to prevent the accumulation of condensed water in the catheter.

(10) When viewing and repairing, special precautions should be taken to prevent scratches, wood, etc. from falling into cylinders, gas cylinders and pipes, as such substances may catch fire in compressed air.

(11) in the cleaning of the cylinder wall, the use of oil, not to use gasoline, scrub the cloth oil can not be too much.

(12) After being cleaned, the cylinder head should be opened to allow the oil to evaporate thoroughly.

(13) When using compressed air,Air Compressor Application the direction of the air flow must not be directed towards the staff.

(14) air compressor connection inside the grease must be carefully cleaned; according to the operation of equipment, cleaning cycle is generally 3 to 6 months.

Solar compressors All air compressors are environmentally friendly, energy efficient, efficient and stable to ensure that you only need to use the energy required to complete the work without causing unnecessary waste, between power consumption and air consumption Of the exact match,Air Compressor Application thereby reducing energy costs and save money, to achieve excellent work efficiency.