Air Compressor Application should pay attention to what safety measures? Air compressor safety measures are many, when used there are a lot of places should be noted that the use of the time should be strictly in accordance with the instructions to operate. Accidents or abnormal operation should be made with the purchase of Chengdu air compressor sales office, and then allow professionals to repair.
(1) When the compressed air is cooled, it is necessary to blow off the mixture of coolers, gas cylinders and oil condensate in a timely manner, at least once per hour.
(2) air compressor in the work, if the cooling water supply is not timely, must be immediately parking to be cooled.
(3) air compressor before starting, the cylinder and the cooler water jacket advanced water.
(4) in the cylinder water jacket is not completely cooled before, not water, to prevent the cylinder wall cracks.
(5) into the water jacket of the cooling water, should be set by the ad hoc water pressure drop into the sink, the water tank installed on the horizontal indicator scale, the level dropped below the limit, the signal device that effect; can also use centrifugal Pump water; do not directly use the water from the mine into the water, because it is difficult to see the water or not.
(6) Drain from the cylinder water jacket or cooler water jacket, must use an open stream to view the uninterrupted effect of all cooling equipment and measure the drainage temperature. Drain temperature than the water temperature shall not be higher than 20 ℃ -30 ℃.
(7) In order to prevent overpressure caused by blasting, in the compressor equipment should be equipped with a calibrated pressure gauge and safety valve.
(8) When the compressed air must be introduced into the lower pressure of the system, you must equipment reducer.
(9) In order to prevent the compressor system from cracking due to the ignition of the gas blasting mixture, the following measures must be taken:
1, the intake pipe should be located in the unclean gas, evaporation and dust, etc. mixed with the position. The inlet of the intake pipe should have a protective cover that prevents rain, snow and other debris from entering.
2, the air through the filter to completely remove the dust.
3, the cylinder out of the air, subject to the special water pipe cooler down to 25 ℃ -30 ℃ or so, to prevent the accumulation of condensed water in the catheter.
(10) When viewing and repairing, special precautions should be taken to prevent scratches, wood, etc. from falling into cylinders, gas cylinders and tubes, and such substances may catch fire in compressed air.
(11) in the cleaning of the cylinder wall, use the oil, do not use gasoline, scrub the cloth oil can not be too much.
(12) After washing, the cylinder head should be opened to allow the oil to evaporate completely.
(13) When using compressed air, the direction of the air flow must never be towards the staff.
(14) air compressor connection pipe inside the grease must be carefully cleaned; according to the operation of equipment, cleaning cycle is generally 3 to 6 months.
Compressors All air compressors are environmentally friendly, energy efficient, efficient and stable to ensure that you only need to use the energy required to complete the work without causing unnecessary waste, to achieve the precise balance between power consumption and air consumption Match, thereby reducing energy costs and saving money, to achieve excellent work efficiency.
- Air Compressor
- Air Compressor Type
- Composition And Structure
- Main Uses
- Market Development
- Control Principle
- Installation Site Selection
- Spiral Lobe Compressor
- Screw Compressor Main Categories
- Screw Compressor Benefits
- How To Choose A Good Air Compressor
- Compressure Of Air Compressor
- Choose Correct Air Compressor Model
- Location Of Air Compressor
- Cooling Water And Water Quality For...
- Compressed Air Quality And Requirem...
- Difference Between Single Screw Air...
- How To Process Screw In Screw Air C...
- Where Are The Energy-saving Air Com...
- Why Air Compressors Use Gas Tanks